Nitrous Installation
#5
Nitrous Installation
#1 Gang the grounds of both solenoids and attach them to a good chassie ground. (Some people take them back to the battery ground.)
#2 Gang both hots off of the solenoids and take them to one side of a hobbs fuel pressure switch.
#3 Take a wire off of the other side of the hobbs to one side of a pushbutton or WOT spring switch.
#4 Take a hot wire from the other side of the WOT switch to a keyed arming switch.
#5 Take a hot from the other side of the arming switch to the battery or a keyed hot somewhere on the quad.
#6 Your done.
Start quad, turn on arming switch, open bottle valve, crank it open, dump the clutch, hit the button..................C ya.
#2 Gang both hots off of the solenoids and take them to one side of a hobbs fuel pressure switch.
#3 Take a wire off of the other side of the hobbs to one side of a pushbutton or WOT spring switch.
#4 Take a hot wire from the other side of the WOT switch to a keyed arming switch.
#5 Take a hot from the other side of the arming switch to the battery or a keyed hot somewhere on the quad.
#6 Your done.
Start quad, turn on arming switch, open bottle valve, crank it open, dump the clutch, hit the button..................C ya.
#6
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)