New video article - G2 Outlander "under the hood"
#1
New video article - G2 Outlander "under the hood"
New video article - G2 Outlander "under the hood"
A look "under the hood" of my 2014 Can-Am Outlander 1000XT. Video at the end of the article showing tips on removing and re-installing 3 basic components of the Outlander - the front "gauge support" panel, the "console" panel, and the seat; and what's located beneath them.
Video:
Full Article:
BillaVista.com - Can-Am Outlander 1000XT - "Under the Hood"
A look "under the hood" of my 2014 Can-Am Outlander 1000XT. Video at the end of the article showing tips on removing and re-installing 3 basic components of the Outlander - the front "gauge support" panel, the "console" panel, and the seat; and what's located beneath them.
Video:
Full Article:
BillaVista.com - Can-Am Outlander 1000XT - "Under the Hood"
#2
NOTE: There is a mistake in the video where I incorrectly identify the vent hoses.
I took the side panels off and traced all the hoses and the correct identification is as follows:
The cluster of 4 are:
Front differential.
Rear final drive (rear differential).
High / Low range gearbox.
Fuel tank.
And the single skinny one on the right side (which I erroneously called a fuel vent) is actually the electric cooling fan vent hose.
I took the side panels off and traced all the hoses and the correct identification is as follows:
The cluster of 4 are:
Front differential.
Rear final drive (rear differential).
High / Low range gearbox.
Fuel tank.
And the single skinny one on the right side (which I erroneously called a fuel vent) is actually the electric cooling fan vent hose.
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Performance Mods and Project Quads
1
07-30-2015 09:39 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)