Replacing A-arms.
#1
#2
This is the best tool to get the ball joints remove from the spindle ATV Ball Joint Separator
http://www.motionpro.com/atvtools.html
http://www.motionpro.com/atvtools.html
#3
#4
I've replaced one upper and one lower a-arm off my '00 and was able to reuse the ball joints in both cases. Remove the clips, put the arm in a vise, and drive or press the ball joint out. A little heat seemed to help a lot. If you are careful you should have no problem reusing the old ball joints. make sure the clips are on right when re-installing. The new arms (at least for '00's) don't come with the ball joints, and I was quoted something like $80 for new ones. You should be able to get the lower arm for less, I think I paid around $90 for the older style.
My experience was that the arms come off pretty easily. I didn't have any problems seperating the ball joint from the spindle and didn't use any special tools.
My experience was that the arms come off pretty easily. I didn't have any problems seperating the ball joint from the spindle and didn't use any special tools.
Thread
Thread Starter
Forum
Replies
Last Post
trouttracker
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
07-20-2015 11:54 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)