Is this a good deal a 12:1 JE piston for 189.00 And thay will port and polish my head install oversized valves for 1750.00 bucks is this good? oh and thay are going to do a flowbench on it.

 

i believe samcoe performance sells that same piston same price. head work, i wouldnt pay that just my .02c worth

 

that is a lot for head work i would want to know, what they are giving me to start with. i got head work and intake manaifold ported for $200, flow bench said 30%more flow. so that is a lot for valves. i believe they are $55 per valve. so tat leaves a lot for grinding

 

dschris, don't spend that much for the head. call custom atv in phoenix 480-969-2863. they have been doing a few ds's. right AZ???
[img]i/expressions/face-icon-small-wink.gif[/img]

 

Hay I just found This cool shop in Tucson. Thay have a complete sunnen mechine shop and chasi dyno that will run bikes and quads. thay said whatever i need thay will get at a good deal. thay even have a flowbench and are willing to port my head. I think it is time for a career change maby i can get a job there it could help all. sorry for the typing I am still sleeping......

 

ok chris i give, who is it?

 

Full Spectrum Performance You should check this place out . here is the phone number 293-9071

 

Hey chris hows it going. The price on the head is close to the ron woods. So if i was going to spend that much i would have the woods head its like 1850. And comes with ported intake too!!but if i were you and could find a local shop to do the work reasonable. I belive i would give them a try. But they must remeber they are not ron woods and do not have the track record he dose and do not deserve to charge what he dose!!! or woods is the way to go he is very proven!!!good luck!!! [img]i/expressions/face-icon-small-happy.gif[/img]

 

DSChris:

How much bigger are the valves? Sam Coe does 1mm larger (than stock valves) and porting for I think $500 but, if you want to get into a FULL Race Head (Pami and Ron Wood) the valves will be 39 inlet and 34 exhaust (I think Ron Wood are 1mm larger on either the inlet or exhaust.)

Does that price include valve springs? Are new retainers needed? What about cams? Is the piston price included in the $1750? If the $1750 is just for larger valves in the head and port work, talk to Ron Wood (like AZ said) or Gottfried. Go with people that have done a few of these, actually, have done a ton of these.