I installed a durablue eliminator axle.It is wider on the right side then the left.I go through the directions and I cant see where I did anything wrong.The c clips are on and the axle is tight.The posi nut tightens off the right c clip right?Do you just use the spacers to even them out or is it installed wrong.

 

You should be asking Durablue.

 

Are the splines on the axel the same distance from the end of the axel on both sides if not u probably have it in the wrong way round
Im not sure if there is an ofset on your machine or not check the old axel and the new.