I have put together a go-kart with a front end of a blaster. I had to widen the arm apart to make room for feet but turned out good. The front wheel bearings are shot though and I cant get the hubs of the spindles. As far as I know they should just come off once the spindle castle nut is removed. Never took the hubs off of any quad that I remember and would just like to make sure nothing else is there before I start beating it off. My guess would be a metal tube between bearings that is rusted on the spindle. Anybody know if it should just come off or not? Maybe pressed? Thanks

I included some pictures and a small video if anybodys curious about it.







Video wont work. Tell me how to make it work if you want to see it.

 

ok, got them off. Rusted on. Had to get the bfh and hammer them off.

 

Hows it run?

 

Runs well, geared for lots of power. Will drag an adult around with ease. It tops out like 40mph maybe 45. Rides beautiful. Been a blast.
Specifications are
16hp Honda clone
21ft/lbs of torque
electric start
comet 40 tav
blaster front has 7.2" front wheel travel
Swingarm Has 6.5" rear wheel travel