i have stock axle and i am getting ready to put on a set of burgard +3 A-arms. What will my bike handle like until i can afford an axle? Please only respond if you really know. Thanx

 

I run a different offset on the front rims than stock. This gives me the front width of a set of +2 A-Arms, and I still run the stock rear axle. I have noticed no ill effects. The increased stability is great. I do not think you will be un happy. Did you get some new shocks to go with those a-arms?

 

I am slightly wider in the front on my R. Cornering seems better this way.
ERIC

 

It will be even better when you widen the rear. I think mine got worse when I got the +2s in front on hardpack, but everywhere else, wider was better.

 

When we were building the TC405ex we had burguard +3 a arms and a stock 250x axle the bike seemed to be all over the place. and landing was a little rough. then we got a +4 LSR axle not the bike runs and feels great. Just watch out and remember that you have a shorther rear end. The new axle will make a huge difference

 

I just got the wheel spacers for the rear(2.5 inches) so it should handle fine now, thanx for your input everyone.