BENT
#2
I used a couple of hydraulic jacks and a come-a-long to straighten mine out. Just takes a little finessing. Oh and you need something to pull against. I used my project car (old Chevelle) that is in the garage. The whole thing cost me $0.00 and about 3 or 4 hours time. Can't tell where it was bent. However, it was only the subframe that was bent. Don't think I could do the same if it was a sturdier part of the frame.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)