Anyone know how to reset the display for the change oil indicator?

 

Owner's Manual, page 28. "To reset the indicator, press and hold both the odometer/tripmeter and hourmeter/digital clock for more than 2 seconds."
Don't feel bad, I had to search for this, and ALMOST resorted to the dealer.

By the way, also have the Stikgards installed, and after out in the mud yesterday I learned they are real mud scoops in addition to guarding against brush damage. Wish they would do something different with the exposed U-clamp ends! Any ideas from the forum?

 

On the exposed u-bolt ends: hacksaw, portaband or side-wheel grinder will do the job.

 

Was kinda hoping to screw something on the U-bolts to protect. Wouldn't it be hard to reuse the same bolts if I grind the ends off?

 

Put a regular (NOT LOCK NUT) on top of the part where you are going to cut. Then make your cut. then use a wrench and screw the nut off. This will make the threads just fine.

 

Thanks Nuke--I should have looked there first. I remember someone saying they took theirs to the dealer to have it serviced and that the dealer forgot to reset the indicator, so I assmed the dealer had to do it.
Take care

 

That was me (with the first service question). The dealer wasn't having any luck finding out how to reset that oil warning, so I looked it up in the owner's manual will still in the dealer parking lot. Enjoy that Rubicon, I sure am....