after jetting my bike i just replaced my plug that was couple years old and its black but the bike is running great wondering if its worth adjusting the fuel mix to get it brown or leave it were its at sence the bikes running good. Havet looked at new plug yet gonna do that soon doing cleaning right now on the bike.

 

i would bring it down a bit. You might gain a little power and some fuel economy back. What mods did you do? I just bought a UNI air filter for mine, but i'm afraid to put it in since it might make it run extra lean. I still have the stock exhaust too, not changing anytime soon. I really dont want to re-jet, since i have an extended warranty and that would most likely void my warranty.

 

i have a uni filter on mine i didnt have to rejet when i put it on but i put on 25inch mudlites and i got a brand new muffler basicly its stock muffler still tho. I put a dyno stage 1 jet kit on my bike to get more power right now i can pull a wheelie in 2nd gear leaning on back of bike.

 

really?? which jets did you use in your kit? I'm buying the same kit soon. does yours run ok with your setup? any flat spots or anything? what about your top speed, any increase? Now i'm kinda excited to get mine.

 

i used a 124 with float pin on clip 4 i gained more low end power but bout same top end takes longer to get to top end 1-3 has alot of power and get up and go 4 and 5 are lil slower then normal but in trails all i use is 1-3 mosty and mud.