Honda Rancher Axel Bearings install.
#1
Honda Rancher Axel Bearings install.
If any one has the book or page about install. please help me out. can email or fax. teh quad is in our garage tourn apart because i left the book at work.
Anyhelp would be a apprictiae.
Ryan
\
rbflurry01@hotmail.com
Anyhelp would be a apprictiae.
Ryan
\
rbflurry01@hotmail.com
#5
Honda Rancher Axel Bearings install.
Here's how I do the fronts.
remove wheel, removed brake drum, unbolt (4) brake panel, take off lower nut on knuckle, use a prybar between the a arm and knuckle be careful not to tare the ball joint seal, push down and use a hammer and hit the a arm where the ball joint goes through.
Once you have the a arm free unbolt the lower shock and lift up the a arm to get the axle out, take off the upper ball joint nut, install the bolt for the lower shock mount, take your hammer and hit the knuckle just above the bearings where it at a angle, the knuckle should be removed now.
Take out the seals find the snap ring and remove baerings.
remove wheel, removed brake drum, unbolt (4) brake panel, take off lower nut on knuckle, use a prybar between the a arm and knuckle be careful not to tare the ball joint seal, push down and use a hammer and hit the a arm where the ball joint goes through.
Once you have the a arm free unbolt the lower shock and lift up the a arm to get the axle out, take off the upper ball joint nut, install the bolt for the lower shock mount, take your hammer and hit the knuckle just above the bearings where it at a angle, the knuckle should be removed now.
Take out the seals find the snap ring and remove baerings.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)