Is where the high and low oil levels would be on a 2008 rubicon CTE????

 

ur oil level should fall some where in the upper flat section of the dipstick topside being high lower side being low for oil level

 

ok

after a 100k run today i noticed it dropped to the bottom of that large flat section......maybe even a bit below.

bike has about 200k now on it...........change oil light did come on today aswell so will be doing that tommorow....

Is it normal for a new machine to burn or loose a bit of oil like that during break in?

 

koolaid beat me to it, i just went to the garage for my shop manual.

 

what about this loss of oil or burn of oil?

Kinda bumming me out a bit

Was at top when i check before run today.......

now is at bottom of that big flat .......

 

my book saws check when warm but not hot or you will not get an accurate reading. Maybe the problem is as simple as that

 

i checked as they instructed in book aswell.

its down from start of day for sure.....

did drive along at 65kph-70kph for about 20mins today getting to trail..........
That cause any issues?

 

you got me man. I have only put 1hr on my rubicon since i got it last week. Going riding sunday tho

 

1hr.........i put that on first night [img]i/expressions/face-icon-small-smile.gif[/img]

Ride mine everyday..........

was a really nice ride today!!

was actually over 100k run.....

 

make sure u check oil level with out screwing dipstick back in just dip it in to the threads