I enjoy reading these forums. I finally registered to ask for some help on my 1984 trx200.

I'm trying to pull the hub off to get at the front wheel bearings. I have a steering wheel puller, and its getting really good pull on the hub, but it isn't budging at all.

I want to make sure that this hub is suppose to slide off before i apply heat to it and really start cranking it down. I'm in the process of restoring it, and i don't want to add to my costs by damaging the hub or spindle. I would love to get my hands on a service manual, but my funds are tied up at the moment.

Any help would be greatly appreciated.

 

Still trying to get this hub off.. I think the colar(?) is what's holding me back. I tried heating it last night, and it wouldnt budge. Anyone have any tricks or advice? I came close to damaging the spindle last night trying to get this thing off, so im pretty much needing a better method to getting these hubs off. My guess is they havnt been pulled in 25 years or so. So they are stuck on thewre big time.

Any ideas?