what is the factory front end tow setting of a 400ex, Dead on the nut equal at 31,1/8 inches rim to rim??Or slightly in? I'm replacing left front tye rod and ITP rolled edge rim from mishap and don't have the stat.

I called the dealer but I might as well have just asked my dog for the setting point.

Thanks.


[This message has been edited by trx430ex (edited 09-15-1999).]

 

DUDE I HEAR YA, i had a little sihap with mine off the table top. What i did when i replaced my tie rod was took permenant marker and marked where the old one was in the bolts and then measured when it was off the machine, i then measured that same distance on the new rod and marked it, then screwed it in until the marks lined up. Got it? I got red labels on mine when the old ones bend, nice rims, the both of us


------------------
~~Mike

'99 400EX, FMFpower core IV, WB Triple rate shox, AC Nerfs, K&N Power kit, Renthal Bars, etc...