Bearings on a 250X
#4
#6
tip........repack em every now and them
use a sering (sugical thing...with out the needle on the end) to suck up grease and place it in the actual bearings (ya remove the seals with small screwdriver)
if ya going to replace em......use the right tools......hubs are EXPENSIVE....remember they are cast
use a marine grease if possible.....and torque wrench to get the bearings set right
bearings are cheap
go to ya local bearing shop and match em.....with ones on the shelf......almost gurantee they will have em in stock
also replace seals (they usually cost more than the bearings)
use a sering (sugical thing...with out the needle on the end) to suck up grease and place it in the actual bearings (ya remove the seals with small screwdriver)
if ya going to replace em......use the right tools......hubs are EXPENSIVE....remember they are cast
use a marine grease if possible.....and torque wrench to get the bearings set right
bearings are cheap
go to ya local bearing shop and match em.....with ones on the shelf......almost gurantee they will have em in stock
also replace seals (they usually cost more than the bearings)
Thread
Thread Starter
Forum
Replies
Last Post
exmotocrosser
Polaris
10
09-13-2019 06:12 AM
Elkaholic
Land, Trail and Environmental Issues
1
09-06-2015 02:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)