My 200SX's clutch slips, gas anybody else had this problem?

 

I have a 200es and my clutch used to slip. All you have to do is buy new friction plates. They are pretty easy to install. The plates are for the secondary shift clutch not the centrifugal clutch. Mine would mainly slip in 2 through 5 gear when i hammer it my motor would rev really high and I would not move then if i let up a little on the trottle it would catch again.

 

Mine are getting worn too.. I just adjusted them (the owners manual has great info on this) and it doesnt slip nearly as bad...one thing: Make sure your foot is completley off the shifter lever before you hammer the gas and it wont slip nearly as bad
Joe

 

The only time mine slips is when I ride really hard for about an hour.

 

Thanks for all the input. I was thinking I would try a new clutch rebiuld kit. Other than that, thanks again.

 

Please remember Stopper that your SX actually has two clutches. A cetrifugal clutch and the normal pack with drive and friction plates. The only way to check the components is to remove the right side cover.

 

I was wondering if anyone has or knows where i can get the specs and pics of a 200sx i need them for my web page i just started
www.geocities.com/dg_300ex
and i need specs for it and the husenberge 400 and 600 thanks
icq uin is 43170971
and email is winky@netrover.com

 

i have a picture of own with sandtires, if you want i can email it to you.