Im looking at buying a truck.Will my 250R with a extended Axle (3" Wider) fit in a Ford Ranger Truck????May have to go Fullsize? late,Zubbeyboy

 

Well, my Zilla (at least 3 inches wider than my stock R) fits in my toyota with its WILD offset paddles/razors.
The rims are flipped, so its REEEEEALLY wide with its paddles/razors on, and it fits in my toyota 4X with about an inch on each side.
(very little)

So, yes it should fit.

-Matt

 

my stock rappy fits in the back of my shortbox s-10 with at least 3-4 inches on each side, so i would imagine that the R would fit in a ranger. My cousins raptor fits in his ranger the same way.

 

I have a 91 Ranger it fits but it is tight past the fender well. It fit better in my 88 ranger.

 

You can drive over the wheel wells if need be.

 

Thanks a lot guys.Kinda sucks,i found a sweet stepside Ranger i could have practically stole but it wouldnt fit.I need 49" at least to get into truck bed.I measured a Fleetside today and i should be aight. late,zubbeyboy

 

My stock Z-400 fits {rides right up in} my 86 Ranger with a little "hammer massage" on the wheel wells.
It's the proverbial $6000 quad hauled around by a $900 truck!

 

It definately wouldn't fit in a regular cab.... you may have to go to a super cab or cab plus and take out a few seats [img]i/expressions/face-icon-small-wink.gif[/img] !!!!!!!!!!! Good luck !!!!!!

 

It will probably fit in any truck bed if you leave the tailgate down. I hauled my 300ex in a lifted 88 Nissan (6" lift with 33's) - those old Nissan's were tiny. The worst part was getting it up there. Pushed it til the front tires hit the roll bar - the back tires were just barely on the tailgate. Just had to strap it down real tight and it was fine.

 

I wasnt worried about Length i was worried about Width.I need 49" wide to fit. late,zubbeyboy