2001 Bayou Speedometer Cable
#1
#2
2001 Bayou Speedometer Cable
Okay, I figured this out so I will answer it in order to assist someone else with the speedometer install. A Kawasaki Tech told me that installing the speedometer on the 2x4 Bayou 300 is "Painfully Simple"....
Right side of engine has a threaded hex-head plug about 6" to the right of the black slotted plug that is above the foot shift lever. Remove the hex-head plug (not the slotted plug) and insert the gear piece vertically straight down into the hole, seating it at the bottom. A small blob of wheel bearing grease can be used to hold the bottom flat washer in place on the shaft when inserting it into its position. The Speedo head mounts on the threaded tabs on the front rack above the left front fender and a hole has to be drilled in the fender to let the cable thru. A parts diagram can be found at:
http://www.buykawasaki.com/EMW...ou%20300%20%282001%29
Hope this helps! Jim
Right side of engine has a threaded hex-head plug about 6" to the right of the black slotted plug that is above the foot shift lever. Remove the hex-head plug (not the slotted plug) and insert the gear piece vertically straight down into the hole, seating it at the bottom. A small blob of wheel bearing grease can be used to hold the bottom flat washer in place on the shaft when inserting it into its position. The Speedo head mounts on the threaded tabs on the front rack above the left front fender and a hole has to be drilled in the fender to let the cable thru. A parts diagram can be found at:
http://www.buykawasaki.com/EMW...ou%20300%20%282001%29
Hope this helps! Jim
Thread
Thread Starter
Forum
Replies
Last Post
22, 300, atv, bayou, cable, connection, diagram, gear, install, instruction, kawasaki, kit, shaft, speedo, speedometer
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)