Fender Trimming
#1
#2
Fender Trimming
No it is not necessary. Most people do it just for the look they want. If your thinking of trimming your fenders I would recomend using some masking tape to play around with different looks. Once you have the tape set where you want it and are sure it's straight you just follow along the edge of the tape with a sharp razor or box knife. Be careful take your time and smooth out the part that you cut with some super fine sand paper. Doing a good job will take some time. If you just half azz it then it'll show in the finished product. Also make sure you like the look with the tape. Because once you start cutting it's a done deal.
Thread
Thread Starter
Forum
Replies
Last Post
400H0
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
10
08-20-2015 07:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)