Hetrick Upgrades
#1
I have a question for those of you familiar with Hetrick Racing..
I currently have a stock engine setup on a 05 Eton 90. I thinking about getting a 28mm carb kit and a Poer Up Kit C.
Just wanted to get everyone's feedback on that setup.
I currently have a stock engine setup on a 05 Eton 90. I thinking about getting a 28mm carb kit and a Poer Up Kit C.
Just wanted to get everyone's feedback on that setup.
#3
I will run nothing but Hetrick products on Michael's mini! There products are the best in our book! He has a built AC 70 with all Hetrick products and this mini will flat out FLY!. I'm not bragging either just another race proven mini. I run him alot in the older age group 90 mini class and he has pulled more then 1 holeshot over alot of hot 90's. He always finishes in the top 5 overall in the 90 class on a 70 quad. But the thing I like the most the quad is still very reliable! You will like the Power up kit C. I started with that and added alot to it. You will not believe what that kit with a good clutch tuneing and that pipe will do. You add that PE 20 carb and Koso intake and Boysen twin petel reeds and Your kid will always have a big smile.
It never fails after every race some little kid and his dad will come over to check out his mini,to see what all we have done to it. They all can't believe it's only a 70. When we built it into a 70 from an already fast 50 this thing had a bad wheelie problem. If you would pin the throttle the thing would throw roster tails and stand up in the air! FACT!
YOU CAN"T GO WRONG WITH HETRICKS!
It never fails after every race some little kid and his dad will come over to check out his mini,to see what all we have done to it. They all can't believe it's only a 70. When we built it into a 70 from an already fast 50 this thing had a bad wheelie problem. If you would pin the throttle the thing would throw roster tails and stand up in the air! FACT!
YOU CAN"T GO WRONG WITH HETRICKS!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




