Does anyone have on of these? If so do you ride in water and mud? how does it do? Thanks

 

Lots of mud and water and no problems yet....

 

Thank you I am thinking about getting one but I wanted to make sure water and mud won't ruin it because I love to ride in that ****.

 

I've been wanting to get one also. How difficult is the install? Any special tools needed?

 

Not too hard, you do need a drill with a small bit (I don't recall the exact size), a screwdriver and some epoxy/JB Weld or some other heavy duty glue....other than that it's just fishing the cable through where it needs to be and mounting the unit

 

i have one on my warrior and dads raptor, first you take off the wheel and hub/brake rotor. then remove one of the rotor bolts best to set it on a block of wood and take a propane torch and heat it up to get the locktite warm then crank on it with a allen wrech.. best to find a socket allen wrench. after you get it out. put the magnet bolt in. install the sensor DO NOT OVER tighten the sensor bolts it will break te sensor!! feed the calbe b4 installing the sensor. and put the wheen and stuff back on and ready to go. the hardest part is the Rotor Bolt! pix in my gallery of mine yet i think. so fairly esay install. i love mine works great! just dont leave it on when u wash your quad/ or let it set out in rain. can ruin the computer. get it from Rockymountain atv onl like 84 bucks with shipping so not a bad deal i got mine for my warrior fromt eh dealer and it was like 94 bucks.. ne more questions ask.