I'm looking at picking up an old Blaster as a project bike. Will likely strip it all the way down since just about everything needs replaced. Figure I might as well do something nice with the frame. Anyone know of a good place (cheap) to get powdercoating done in the Ohio area? Also, has anyone painted themselves and had it turn out well? How would paint hold up? Is there any specific kind of paint to use?

 

paint will chip after a short time....i would get it powder coated myself

 

yep, go with powdercoat, that stuffs indestructble from what ive seen.

 

Go for the powdercoating. If u were in Oklahoma, I could help you out.

Check on the rriders.com forum, there is a guy on there that does alot of powdercoating work, and seems like hes in your general area somewhere.