I need a little help with my LRD pipes. I just swapped somebody for them, and I am not sure how to set them up. For moto-x racing where do most of you have yours adjusted to? All the way togather,or half way apart,or all the way apart? When I got mine the guy that had them had liquid gasket all over the middle of the pipe where the two halves join. Do they leak that much exhaust? It seems the two halves do not fit togather super snug, so is there something you guys do to keep the two halves tight? Thanks for any replies helping me out!!

 

I have a LRD for my Blaster and they do leak exhaust, use some copper silicone or other high temp silicon. My experience with them i would set them about the middle or maybe a little closer together.

 

i HAVE THEM USE ULTRA COPPER SILICONE U NEED TO TAKE THEM APART AND CLEAN ALL THE OLD STUFF OFF AND PUT A GOOD BEAD ON THE MALE PIPE ABOUT A HALF INCH FROM THE END U NEED TO REALLY SEAL THEM UP GOOD U LOSE POWER IF NOT, AS FAR AS ADJUSTMENT I HAVE A lrd 380 BIG BORE AND HAVE MINE SET ABOUT IN THE MIDDLE. ADJUSTMENTS DO MAKE A DIFFERENCE U HAVE TO FIND WHAT WORKS BEST FOT U AND THE POWER U HAVE. THESE ARE THE BEST PIPES GOING