Quadracer won't start
#1
i have an 87 lt250r that wont start. yesterday i was riding it as about 1/2 throttle and it died. i was low on gas so i thought that i had run out but there was still some in the tank. today i put some gas in it and tried to start it but it wouldnt start so i changed the plug and it was covered in oil. i kicked it a few more times them i changed the plug and once again it was covered oil. with the new plug in i kicked some more and a few times it backfired like a gun. i hope one of you could tell me what is wrong with my quad. by the way about a month ago i got a new piston, rings, cylinder sleeve, and crank case. this is the only problem since.
#2
Hiya,
It could be any number of things. Stuck reeds... Faulty ignition. Make sure you have spark by touching the electrode of your plug to the frame.
Put in a fresh plug... Stick it in 5th gear and pull in the clutch. Let someone pull you to about 30-35mph and see if it will pull start. It may just be that your cylinder is so flooded you can't kick it fast enough to get it to fire up.
It's so tough to diagnose a problem via a forum.
It could be any number of things. Stuck reeds... Faulty ignition. Make sure you have spark by touching the electrode of your plug to the frame.
Put in a fresh plug... Stick it in 5th gear and pull in the clutch. Let someone pull you to about 30-35mph and see if it will pull start. It may just be that your cylinder is so flooded you can't kick it fast enough to get it to fire up.
It's so tough to diagnose a problem via a forum.
#3
#4
Same thing happend to me turns out it was the ignition.Follow the spark plug wire up to the black box looking thing, wiggle the wire alittle bit.After I did it to mine it started in one kick!
1991 Lt250r :
Ceet seat cover,DG alloy front bumper,DG alloy rear grabar,DG alloy nerf bars ,Emgo bars,Pro design kill switch,Maier plastic(Looks awsome I put lots of cool stickers on it),Uni air filter,Shockwears,Parking brake block off,RTC clutch lever,Motion pro twist throttle(took a while to get used to!),Leager A arms ,Ohlins front shocks(got them with the quad the look kinda old),Homemade motor skid(from speed limit sign),Turf tammers on back,IPT hole shot up front,And probly other stuff to but I cant think of all of them rite now. Please go to www.screaminglt250r.homestead.com
1991 Lt250r :
Ceet seat cover,DG alloy front bumper,DG alloy rear grabar,DG alloy nerf bars ,Emgo bars,Pro design kill switch,Maier plastic(Looks awsome I put lots of cool stickers on it),Uni air filter,Shockwears,Parking brake block off,RTC clutch lever,Motion pro twist throttle(took a while to get used to!),Leager A arms ,Ohlins front shocks(got them with the quad the look kinda old),Homemade motor skid(from speed limit sign),Turf tammers on back,IPT hole shot up front,And probly other stuff to but I cant think of all of them rite now. Please go to www.screaminglt250r.homestead.com
#5
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)