anyone have any good tips on getting off a stripped lugnut. i need to put the new holeshots on but this one stripped lug on my one side is screwin me. and its on there so tight that pliers won't work. im riding around on one b/n holeshot and one bald old stock ohtsu. i'd appreciate any suggestions

 

Get a an air hammer for an air compressor with a chisel on it and it'll take it off.

 

You can drill the lug and nut out and replace them, the lug is a pressed in splined lug like on many automobiles.
The Honda part No.s for the TRX250R (I think they are the same for the ATC)
Bolt, Wheel 10X36 90103-HA2-003
Nut, Wheel Cup 90304-HA2-003

 

I ASSUME ITS A 17MM LUG NUT....IFS IT ROUNDED OFF, TAKE A 16MM, OR A STANDARD SOCKET A TAD BIT SMALLER....PUT IT ON A LONG EXTENSION, USE A RUBBER DEAD BLOW HAMMER, BEAT THE SOCKET ON...IT SHOULD TURN THE NUT OFF...YOU MAY HAVE TO HEAT THE NUT FIRST TO EXPAND IT A LITTLE BIT...