In general, how hard is it to change a swingarm? I'm pretty good mechanically, but I've never attempted this type of mod before.

 

Its very simple. Really all you have too do is unbolt it from the frame and then unbolt the shock. This will free it from the frame and then you can start removing the axle carrier etc. It should only take about 15 min to remove it.

 

Really? Looking at them it seems like it would be more involved than that. Are there any bearings to worry about?

 

There are some bearings where the swingarm bolts to the frame, but they should not be an issue. It is really quite simple. Just pay attention to whaat you are taking off and remember where everything goes.

 

Cool, thanks for the info...