Polaris hawkeye
#1
Polaris hawkeye
Ive been having starter issues with my polaris - starts no problem with the pull starter ,but wont turn over when turn the key - ive checked the battery is fully charged , cleaned all terminals ,earth connections ect , the neutral light is coming on , ive replaced the starter solenoid , when i turn the key the starter solenoid makes a clicking noise but motor not turning over anyone had similary problem or got any ideas?
#2
#3
#4
#5
checked small red/white wire from ignition to solenoid - disconneced wire at join and have 12.8 v from ignition switch side when I reconnect wire have no volts when turn ignition key ? hope all is wired up correctly - have 12 volt battery lead and 2 other wires on 1 pole of starter solenoid (top pole ) - power cable to starter on other pole ( bottom ) , 2 small wires from solenoid 1 of which goes to ignition switch ( colour coded only go one way ) - could 1 have the pole wires **** about - would it make a difference ? thanks again for your assistance OPT
#6
Sounds like the solenoid wiring is ok,also from the switch,have you checked that could be binding at bendix in recoil area? About last thing I can think of unless the starter is requiring more voltage to turn over. Have had this happen when starters were not free enough(even after cleaning) to operate on 12 volts from solenoid and needed replacement! (dragging) OPT
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)