2 stroke problem
#1
2 stroke problem
i have a 93 Polaris 350 and need to rebuild the topend, there is no machine shop within 150miles of my home, does anyone know a reliable shop where i can send it to get it bored? any suggestions on the best lace and best kind of piston to get? any help would be appreciated.
#2
#3
2 stroke problem
You can take it to a local NAPA autoparts shop, or send it off to doug nicholas at nicholas cycle to get it done.......his number is on his stie(www.nicholascycle.com)........Also go with a wiseco like he said.....much more reliable
#4
2 stroke problem
Well, I"m having the same problem, and the polaris dealer quote me $780 for rebuilding the top end. What do you think about this price, and is it worth putting a thousand bucks in this bike? It's high milage, worn a lot, but mostly has run well. Any opinions? Also how much would a wiseco piston add to the cost?
Thanks!
Textrout
Thanks!
Textrout
#6
2 stroke problem
$780 to rebuild a 2stroke is ridiculous. $780 should get you a BRAND NEW cylinder and a wiseco and a couple hundred dollars leftover [img]i/expressions/face-icon-small-wink.gif[/img]
You could send it out to RCR (www.rittercycle.com), its around 35 to bore/hone out the cylinder and 100 for a wiseco piston. So for $150 including shipping, the top end will be ready to go.
Add in another 15 or so if you need a new upper needle bearing, and 15-30 for a gasket set.
It is very easy to disassemble and reassemble yourself, just make sure to lube everything up well with 2stroke oil.
-Chris
You could send it out to RCR (www.rittercycle.com), its around 35 to bore/hone out the cylinder and 100 for a wiseco piston. So for $150 including shipping, the top end will be ready to go.
Add in another 15 or so if you need a new upper needle bearing, and 15-30 for a gasket set.
It is very easy to disassemble and reassemble yourself, just make sure to lube everything up well with 2stroke oil.
-Chris
Thread
Thread Starter
Forum
Replies
Last Post
TLC
Honda
7
07-11-2015 02:28 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)