Black and White Primary Spring
#1
Black and White Primary Spring
Hi Everybody,
I am writing because I just installed a Dalton Black and White primary spring I purchased from RCR. In low gear it feels great but when I put it in high gear it feels like a slug once it gets rolling at around 30mph it revs up really high like the belt is slipping it kind of freaks me out I was wondering if that is how it is suppose to be.
Thanks,
Victor
I am writing because I just installed a Dalton Black and White primary spring I purchased from RCR. In low gear it feels great but when I put it in high gear it feels like a slug once it gets rolling at around 30mph it revs up really high like the belt is slipping it kind of freaks me out I was wondering if that is how it is suppose to be.
Thanks,
Victor
#2
Black and White Primary Spring
Found the problem I took the secondary apart to switch it back from 1-1 to 2-2 and when I did this i didn't prelaod it enough witch cause the belt to be slow on takeoff and to slip at higher mph all fixed now I can pull the tires up about two feet and ride it out for about 10ft. before the spring I would have to practicualy rip my arms out of the sockets to get the tires up 6in. Best $30 invested so far.
Victor
Victor
Thread
Thread Starter
Forum
Replies
Last Post
Steeldon
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
09-09-2015 09:38 AM
Elkaholic
Land, Trail and Environmental Issues
1
09-06-2015 02:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)