im wondering if i could fit 25-10-12 kenda executioners on my 2006 polairs hawkeye any suggestions

 

really need some help

 

Wish I could help... but I'm waiting to hear the answer, too.

I swear someone around here claimed they put 25's on a Hawkeye with no problems ... but dont' take MY word for it. Let's hope they come here and pitch in.

 

if you do a search you will find some people have put 25" tires onthiers not sure about width.

 

I have 25" mudlites on mine that are 10" wide on the rear on stock wheels and I have no problems.

 

I'm fairly certain rickeyparker has 25's on his Hawkeye.

 

I have mudlites on my and they fit but varied. There is about .25 in clearance on the front of the rear tire where it meets the running board/fender area under compression. I believe mudlites run small. If Kenda run a true 25" and the thread depth is more, than I would say no.

 

i talked to a local dealer and he said the excutioner 25-10-12 was 1/8 away from hiting so they where to close.
i really want a decent mud tire on this atv

 

I have 25" TerraCross's on my 07 and 25" ACT's on my 06, the ACT's are 11" wide and rub the outter footwell lip slightly at high speeds otherwise no rubbing anywhere else....

 

I forgot to put that my mudlites are on factory wheels. Most aftermarket wheels have to much offset for Hawkeyes. The dealer I purchase mine from had some aftermarket alum. wheels with 25" Kenda bearclaws (which run short) and he trim a little from the outer lips from the bottom to about 6 inches up. Since I have had this thing (jan 3, 07) its done nothing but rain about twice a week, so I ridden in lots of mud, not the soupy stuff, but heavy stuff almost to the floorboards without a single problem. By the way, has anyone found an aftermarket muffler yet? I call Aaen and they didn't even know what a hawkeye was.