I know there is a circlip holding the shaft in the CV joint and once that is out, how does one go about getting all the insides out so I can clean them properly? I plan on working on this tomorrow night at work, I love my job. Thank you for your knowledge.

 

Nevermind I just took it to work and decided to go for it, complete success! I must say sometimes working on these machines is just as fun as riding them [img]i/expressions/face-icon-small-smile.gif[/img]

 

Nice to hear it worked out dodgeman.

 

there not too bad to work on w/ the right tools and the know how, but can be frustrating when crap/rust holds them in for sure.