Tips to remove front driveshafts?
#1
Tips to remove front driveshafts?
I have a '97 Xpolorer and would like to remove the front eccentric. Both shafts need to be removed however, I cannot tap the roll pins out - won't budge. With the limited angles that you can position the punch at it is hard to strike it with any kind of force.
Any tips?
Any tips?
#3
Tips to remove front driveshafts?
I found the best way to do this is from the front of the machine, line the roll pins up horizontally and come at through one of the holes in the frame. On the left side the front eccentric pinch bolt is in the way and needs to be removed. Use a punch the exact size of the roll pin, a heavy hammer and a lot of force.
#4
Quad Patrol
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
#6
Quad Patrol
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Don't let the hp numbers fool you. Its all in how you get it to the ground. Clutching clutching clutching!
Thread
Thread Starter
Forum
Replies
Last Post
JackTheKing
General Chat
40
07-14-2015 09:09 PM
ATVC Correspondent
Technical and How-To Articles
0
07-02-2015 01:34 AM
2002, 97, atv, drive, driveshaft, driveshaht, front, mountaineer, pin, pins, polaris, remove, removing, roll, shaft
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)