I am looking for harness end that clips into the ignition switch on my 2005 Magnum 330. I have a short in the connection and instead of redoing the entire harness, I thought I would splice one in instead of replacing the entire harness below the handlebars.

Thanks

 

There are a couple sections in Parts Unlimited,Tucker Rocky,and K&L catalogs that have various electrical connectors,BUT I havent seen the one for the key switch. This a hard to find one (at least I havent found one ) You can purchase the connector pin tool with an assortment of pins and redo your connector. The harness your talking about is the complete wiring harness as it includes the switch connector. We have a couple old harnesses from wreck/totaled jobs that we keep for this same purpose if a machine comes in from rat damage,theft,etc. You can check some salvage yards if any around your area. OPT

 

Hey-great suggestion. Where would I find the pin tool. I've been searching for the scrap option with no luck. That is what I was hoping for. I understand the harness is $$$$$.

Thanks

 

[QUOTE=manum;2882288]Hey-great suggestion. Where would I find the pin tool. I've been searching for the scrap option with no luck. That is what I was hoping for. I understand the harness is $$$$$.

Thanks[/

The harness is over $200 and a time consuming job for just one connector! The best tools are on the tool trucks,Snap-on,Mac,Cornwell,and Matco. My mechanic(rather my replacement) has a set,but dont know the cost,SHOULD be a lot cheaper than a harness kit OPT