700 air mixture screw
#2
700 air mixture screw
1} Pull the carb of the engine - can leave the choke and throtle cables attached.
3} The plug will be on the underside of the carb. Just in from the "Opening" that was in the boot on the engine side of the carb.
4} Its the only brass plug on the bottom of the carb and it does have a REAL small whole in the center of it. Its wide enough to slide
a 24 gauge IV needle into it IE: DARNED SKINNY. But does work nice as a pilot whole. And it is rather deep. I checked, then checked
and recheked again as I drilled mine out. Cuz The Polaris manual pics werent the best.
hOPE THIS HELPS
3} The plug will be on the underside of the carb. Just in from the "Opening" that was in the boot on the engine side of the carb.
4} Its the only brass plug on the bottom of the carb and it does have a REAL small whole in the center of it. Its wide enough to slide
a 24 gauge IV needle into it IE: DARNED SKINNY. But does work nice as a pilot whole. And it is rather deep. I checked, then checked
and recheked again as I drilled mine out. Cuz The Polaris manual pics werent the best.
hOPE THIS HELPS
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Performance Mods and Project Quads
5
10-10-2015 10:20 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)