2004 500ho shuts off when using high beam lights
#1
10-11-2019, 06:47 PM
Join Date: May 2003
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
2004 500ho shuts off when using high beam lights
Long story short my battery light was flashing when at 3000+ RPM , diagnosed it as the voltage regulator because I was getting 18.4 volts . Purchased a new ECM from Polaris, swap went easy . First drive notice my cluster would light up, then shutoff and everyone come back as normal. First ride tonight and when it’s running and I switch to hi beam it dies, nothing at switch. Turn lights off and starts right up. Low beam works great but can’t switch it to high without it shutting down. Any suggestions where to start to look? Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)