After torqueing bolt I can't get the cotter pin hole lined up?
Jan 18, 2004 | 09:22 PM
#1
Thread Starter
|
Pro Rider
Joined: Nov 2003
Posts: 223
Likes: 0
After torqueing bolt I can't get the cotter pin hole lined up?
If I torque the bolt that holds the hub on my 03 Z400 quad I can't get the cotter pin in because teh hole is not lined up with the nut correctly, what can I do?
Jan 18, 2004 | 11:51 PM
#2
Pro Rider
Joined: Nov 2002
Posts: 258
Likes: 0
After torqueing bolt I can't get the cotter pin hole lined up?
Tighten the nut good and tight, then back it off till a hole alligns with it. As long as the pin is the right size even if it does loosen a bit, it won't allow the nut to slack off to the point the hub gets wobbly.
Thread
Thread Starter
Forum
Replies
Last Post
Steeldon
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
Sep 9, 2015 09:38 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)