So says the single guy, who hasn't a clue how a marriage works. [img]i/expressions/face-icon-small-frown.gif[/img] "What's her's is her's and what's your's is her's!" And don't you forget it.[img]i/expressions/face-icon-small-shocked.gif[/img][img]i/expressions/face-icon-small-disgusted.gif[/img]

 

Well said sir, well said!

 

Don't let my wife hear you say that![img]i/expressions/face-icon-small-shocked.gif[/img][img]i/expressions/face-icon-small-happy.gif[/img][img]i/expressions/face-icon-small-wink.gif[/img]

 

Good Evening PSAR

Randy,

Tony pressed in new needle bearings for you, did you have to replace the two seals on the inside of the arm? If not, how did you get them out, along with that short bushing next to the seal?

 

Quality swinger questions huh Happy? [img]i/expressions/face-icon-small-shocked.gif[/img]

 

Yes Sir, gotta make sure before digging things out [img]i/expressions/face-icon-small-wink.gif[/img]

 

And anything you ever will have will be hers. [img]i/expressions/face-icon-small-shocked.gif[/img]

 

No, I didn't have to replace either the seals or the bushings, they had only 2 or 3 rides on them so I reused them. I used a socket the same diameter with an extension and tapped them out. Then with a flat piece of steel or aluim get them started and tap them in. Once there in use that socket to seat them below the outer edge so there's room for the seal then tap the seal into place. Just take your time and be careful.

 

I'm doing great! How about you? I'm lookin forward to Florence, that is, if we can go!

 

As far as I know!! I hope so, I really want to ride [img]i/expressions/face-icon-small-smile.gif[/img]