Raptor jeting
#12
Raptor jeting
Just curious, but what do they run for main jets? Are the needles the same as the DynoJet kits do you happen to know? I'm going to pick up them pilots today and try them out to see the difference. I'm running 148 and 146 Mains, 3 Turns out on the Air/Fuel Mixture Screw, and my needle on the 4th clip from the top as DynoJet suggested for my altitude of 800feet. I have full Exhaust, and a K&N Pro-Design intake w/ no lid. What mains are most of you running with the similar setup? I wanna make sure I'm running good, I have a race with a XC Predator with a pipe on it and last time I raced a bone stock Pred with my mods it was pretty close with traction probs on my side... I would pull very little when we were on a icy road with studs(winter), but I think I shoulda been running my 150/148 mains and it wasn't getting the top end it should have.....
Thread
Thread Starter
Forum
Replies
Last Post
Alex Rodak
ATV Videos
2
09-13-2015 12:30 AM
Alex Rodak
Yamaha
0
09-12-2015 09:39 AM
Alex Rodak
Introduce Yourself
0
09-11-2015 11:42 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)