Help with 35mm banshee setup
#1
Help with 35mm banshee setup
Hey guys, I am new to the world of 2-stroke quads, but speed is in my blood. After owning my first banshee for 2 months I started building my second one. I have just bought the trinity stageIV 35mm carb kit, but I am having a problem getting it all installed properly.
First, I also have reed spacers, and with the bigger carbs, the throttle cables don't seem to clear the cross-tube under the tank and above the carbs. Currently, just to test fire the beast, I have them aimed out the right side of the bike and then they loop back.
Second, My boost bottle is literally rubbing up on the exhaust. The stage IV intakes seem to put the bottle up higher than stock and therefore sits against the pipe on hte left side.
Any help would be appreciated, my e-mail address is: jeepchild69@hotmail.com Thanks in advance for any help.
First, I also have reed spacers, and with the bigger carbs, the throttle cables don't seem to clear the cross-tube under the tank and above the carbs. Currently, just to test fire the beast, I have them aimed out the right side of the bike and then they loop back.
Second, My boost bottle is literally rubbing up on the exhaust. The stage IV intakes seem to put the bottle up higher than stock and therefore sits against the pipe on hte left side.
Any help would be appreciated, my e-mail address is: jeepchild69@hotmail.com Thanks in advance for any help.
#2
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
07-07-2015 11:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)