I just put a new clutch in and now it will not even turn over. All I hear is a clicking sound from the solenoid. The battery is good, and I tried jumping it off and using a jump box. What should I do 1st to diagnose the problem?

John

 

put it in neutral and try to start it...

 

I did, and the same thing happens.

 

Try holding the clutch in and start it.

 

does it make NE noise ??? when tried to start

 

Ok my buddy had a warrior that did the same problem they will be a cable next to the header I think to the right of the header if your standing in front of the warrior and they will be a bolt on the end of the cable , check and make sure that is not loosend or it will do that sometimes and if its not, wiggle it around a little.

PS Its the starter cable I think going to the soilinoid. I am not for sure.

 

i had a 99 warrior and that's all i did i got so made that everytime i went out and try to start it i would hear a clicking or a buzzing sound buy the cylenoid i finnally sold it but i messe around ith the wires maybe a little of water or not plugged in properly fiddle with them a bit make sure they are ok and that worked for me the night before i sold it it started right up sell it cause the next thing will be your starter and so on
buy a 400e best dam bike in the world

 

Make sure the battery is charged - stick it on a charger for a while if ya dont find any bad connections.

 

The battery is fine, and it is making sound like when the battery is low. It just clicks at the solenoid. I have tried it with the clutch in/out, neutral/ingear. It must be a connection somewhere or a fuse, I just didnt know where to start looking. I guess I will hit my new Clymer's up when I get home. [img]i/expressions/face-icon-small-smile.gif[/img]

John

 

by the grab bar all those wires... try cleaning them out...