banshee?
#4
#5
banshee?
Typical prices are around $30 per cylinder for the bore job ......standard wiseco pistons run about $150 for the pair.
Then you will need a top end gasket kit (base and head) for around $30
I would also change the wrist pin bearings for around $25
That should do it.
And...as mentioned....I would do .020 over...that will leave you plenty of room for future rebuilds.
Then you will need a top end gasket kit (base and head) for around $30
I would also change the wrist pin bearings for around $25
That should do it.
And...as mentioned....I would do .020 over...that will leave you plenty of room for future rebuilds.
#7
Trending Topics
#8
banshee?
HOLD ON MAN!! If it's never been bored before you probably dont need .90 over, bore as little as possible. If you can get away with .10 DO IT. .90 isn't going to make you any faster maybe 2 HP. THe only bore that will do anything is a big bore. .90 over is your last bore dont use it unless your cylinders are really screwed up and you need it. If you want HP get a port job. PLEASE DONT GO .90 UNLESS YOU NEED TO.
#9