yes, i have hauled them that way before....

 

i would hold the back brake instread, because if you move the wheels while in gear its bad for the tranny i believe

 

on my rappy i took off the rear break cause all it did was cause probs so i can only put it in gear.

 

what problems did your back brake cause? There will be a bigger problem when your atv and you are wrapped around a tree beacuase it was wet and you couldent stop... Think smart bro especially with a fast machine like that..

 

i could be wrong....but he may just mean the e-brake,,,,,which is garbage anyhow

 

I always put mine in gear,,,,,roll it till it locks ,,,,then just tip it back,,,,,it wont hurt the tranny

 

i second that! I put it in gear and it didn't do anything! and i just tiped it up like that ( on the back grab bar) and it leaks a lot of gas. is this good? it doesn't seem too good!

 

p.s. i meant the parking break! the safty switch always gave me probs with backfiring so i took it off!!!!!

 

With the engine running, turn gas valve off, run gas out of carbs.
Then put her staning on her @ss and she will be fine.......

 

Should i let it go as far as stalling? without any gas going into the carbs?