Valve adjustment & carburator question
#1
Valve adjustment & carburator question
Yes I have dont tons of searching before asking these question.
I’ve been playing with my Raptor all day trying to get it to run 100%, no luck so far. I adjusted the valves at least 5x and had to re adjust the float levels. It still stumbles a little but instead of mid throttle it does it just a little now at the beginning. After adjusting my valves I still get a little valve tick. I followed the instructions to a T and re checked it many times. When I started there was 0 clearance. I set the intakes to 10mm and the Exhaust to 16mm. I adjusted, started it, rode it, let it cool and re adjusted many times but still get a little tick.
My main question is about the little clip with the O ring and spring that holds the needle in place and clips down in the 4 fingers that hold it in place. Does the O ring clip into place and that is all that hold it or does it push down further so the top outer ring clips into place down in the fingers? It seems awful loose if it is just the O ring that holds it in place.
I’ve been playing with my Raptor all day trying to get it to run 100%, no luck so far. I adjusted the valves at least 5x and had to re adjust the float levels. It still stumbles a little but instead of mid throttle it does it just a little now at the beginning. After adjusting my valves I still get a little valve tick. I followed the instructions to a T and re checked it many times. When I started there was 0 clearance. I set the intakes to 10mm and the Exhaust to 16mm. I adjusted, started it, rode it, let it cool and re adjusted many times but still get a little tick.
My main question is about the little clip with the O ring and spring that holds the needle in place and clips down in the 4 fingers that hold it in place. Does the O ring clip into place and that is all that hold it or does it push down further so the top outer ring clips into place down in the fingers? It seems awful loose if it is just the O ring that holds it in place.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)