banshee swing arm bolt won't drive out, help!!!!
#1
#2
banshee swing arm bolt won't drive out, help!!!!
If you haven't tried already, spray a alot of WD-40 in there and let it sit for about an hour, than spray it again, get a small diameter(sp?) piece of solid steel(I used a piece of rebar) about 2 ft. long, get a big azz hammer and let 'er have it. If that doesn't work, you could try heating the outside of the "housing" and try hammering it out. These things have a tendency to be a b1tch to get out. I've seen someone have to actually cut the bolt before. When you do get it out, clean that thing up really good with some high grit sand paper, and use plenty of lube when reinstalling.
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
07-07-2015 11:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)