Problem with 99 Banshee
#1
#2
#3
#4
#6
Problem with 99 Banshee
I dont remember spliting the case to replace the shifter shaft. You do have to remove the stater caover to get to the retaing screws. If I remeber right you do have to pull the stater too. Then the shaft pulls out one side. The spring in the fork is usually the problem. Used to be less than 30 bux for the part but its been years since ive replaced one. It did happen to me but it was stuck in second gear. Not to hard but the adjustment can be tricky. Buy the Banshee Manual and read up on it. It will help a bunch
Its been a while so enFORCER may be right.
Its been a while so enFORCER may be right.
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
07-07-2015 11:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)