warrior sticky throttle?
#1
warrior sticky throttle?
bikes been sittin in the garage for a few weeks. i start it up starts first try. the nwhen i get to about 3/4 hrottle it starts cutting out and then if i pin the throttle down it sticks and then slowly relaeses. i have cleaned out the carb except i cant get to the float bowl becuase the screws are stripped. anyone know how to get stripped screws off. also what is my problem?
#3
warrior sticky throttle?
To get the screws out get a dremel and cut a straight groove in the screw head with a thin cutting wheel and you should be able to use a flat head screwdriver to take them out. The throttle sticking problem I'm not sure about, but you could check your throttle cable if the throttle is releasing slowly, it might be time for a new cable
#4
#7
Thread
Thread Starter
Forum
Replies
Last Post
MeadowlarkFarm
Test Your Signatures (sigs) Here!
3
11-27-2019 08:40 PM
fordfaithful21
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
9
12-07-2015 05:52 PM
craacker
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
6
09-09-2015 04:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)