How do I replace exhaust?
#1
How do I replace exhaust?
I want to change back to the stock Yamaha exhaust from a full White Bros. system that is on my warrior. The noise is too loud with the White Bros. (I don't want to deal w/the cops anymore). Can I just put the old pipe and exhaust back on, or do I need to re-jet the bike? The motor is currenlty jetted and bored 4 over.
Thanks
Thanks
#3
#4
How do I replace exhaust?
$20? Come on. I understand how to take off and replace the exhaust, gaskets, pipe, etc. My main question is, do I have to make any internal mods with the motor previously jetted and bored out? My concern is, the stock muffler is for the STOCK motor and not one bored out and jetted.
#6
How do I replace exhaust?
If it had to be rejetted for the WB, you'll have to jet back down for the stocker. When you're taking off that header be DAMN careful that you don't put much torque on the header studs, if they are a little stiff spray some penetrating lube on them and let it sit for at least a few hours. They break very easily because of all the heat cycles they go through, and are a lot of trouble to replace.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)