piston and cam for 95 wolverine
#1
what is a good lift and duration cam for good low and midrange tork, that will not hurt my top end. also what compresion piston is good to go with it.i want to be able to spin 25 inch tall tires in mud without a problem, and still be able to run with the 23 inch tires if i want. i just ordered the e-searies pipe, jet kit and tork stuffer. any help would be great
#4
Go to www.Powroll.com, they make any size cams, valve springs and i think a big bore kit also.Their prices are great! Check it out!!!
#5
I have a 00 wolverine. I went thru Alba (they are in your dirtwheels magizine) I put a 10.750 to 1 Piston in I also bored .02 over. I believe a .380 cam.Also heavier valve springs with titanium keepers, a FMF muffler, same size carb but with a higher flow rate and rejetted, drilled air box, K&N airfilter. I can lift the front end off the ground going thru the first 3 gears with a 40lb winch on the front. Cost was about $1100.00 with out labor on bike. Call Alba for help.
Thread
Thread Starter
Forum
Replies
Last Post
exmotocrosser
Polaris
10
09-13-2019 06:12 AM
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)