91 Blaster Lower Chain Roller Installation
#1
91 Blaster Lower Chain Roller Installation
I just bought this ATV and it needed a new lower chain roller. I bought a Moose sealed roller kit with the hardware. The frame currently has a "stud" or "frame boss" that I just slipped the polyurethane roller on to and secured it with a bolt I had (by screwing the bolt into the "stud" from the inside of the frame). However, I got the other roller with the hardware because the existing "stud" or "frame boss" was pretty chewed up from the chain going over it without the roller. I originally tried to "tap out" the "stud" with a hammer but when it didn't give I left it alone because I didn't want to break it. It has what looks like an allen wrench hole on the "stud" that faces the outside of the frame, but I looked at it closely and the hole looks cicular so I don't think an allen wrench would fit it. I'd like to install the aftermarket hardware because i'm not sure how long the current "stud" will last in its current condition. Any ideas?
THANKS!
THANKS!
#2
Thread
Thread Starter
Forum
Replies
Last Post
Frisky2050
Buying an ATV
10
04-09-2020 11:19 AM
joeyupton
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
07-14-2015 11:51 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)