my warrior doenst want to start!!
#1
Guest
Posts: n/a
i have a 2000 warrior and it doesnt want to start. when i press the start button the celnoid just clicks. i bought a new battery and it still does the samething. SO ITS NOT THE BATTERY!! i got the starter tested and it works fine what wiring could be causing this or is something shorting out. i checked all the fusses the are all fine.
thanx for reading this!
thanx for reading this!
#3
Check the connections on the battery again, clean them and put a little wd 40 on them. Follow the ground wire from the battery, remove it and clean the connection up( i think it is ground on the engine ). It just sounds like it is not getting enough juice. You may also want to try jump starting it if all that fails. Hate to see you look to hard, just to find the new battery wasnt fully charged at time of purchase. Hope this helps you some.
#4
This could be a couple of things... Try doing this (I had the same problem with my Warrior). While holding the start button, reach back and wiggle the celnoid up and down. The got my bike going every time.
My guess is that you're not getting a good connection somewhere. You might want to take your battery out and clean off all the terminals on it.
2001 Yamaha Raptor (GYT-R Bumper, GYT-R Graphics, DG Skid Plates, Pro Design Kill Switch)
1988 Yamaha Warrior (too many mods to list... FOR SALE)
My guess is that you're not getting a good connection somewhere. You might want to take your battery out and clean off all the terminals on it.
2001 Yamaha Raptor (GYT-R Bumper, GYT-R Graphics, DG Skid Plates, Pro Design Kill Switch)
1988 Yamaha Warrior (too many mods to list... FOR SALE)
#7